Has anybody got a good clear shot (the larger the better) of the tail wheel on this beast from the port side? It's driving me batty trying to figure out the locking linkage arrangement. How can you draw what you don't understand?
Last edited by Otterkins2; 14th June 2008 at 01:50.
Even more help yet Zamex! TYVM! Look at the shapes BEHIND the yoke and brake arm though. This is the area that is confusing me. Actually this tail wheel setup was common to most of the later Fw 190's, so any picture that gives me a clear understanding of that area will help enormously. Am I being too fussy about my line drawings?
Last edited by Otterkins2; 16th June 2008 at 00:14.
Isn't it standard for all 190s?
No one has the landing gear book?
Have you seen these Otter?
I'm not sure if I understand which part you can figure out, you mean the double cylinder that the yoke and leg attach too?
back home in 3-4 days
get profiling again 
Linear Mode
