After receiving such an encouraging welcome here I though I would post a WIP of my current project, Again its an Aircraft (RM797) that is currently being restored to airworthy condition here in Oz.
I have only done to basics thus far on both the front and rear, mostly concentrated on the mid section at this stage. Its all a little clean at the moment, wont remain that way for long tho.
I have just read the stencil thread below, and have been looking for a way to add stencils to this profile, does anybody have an appropriate resource they could point me to? I have one for a Vc but I am unsure if this would work her on the later model.
Much work still to be done.
GFR
