Yep, one step forward, 3 paths back
Speaking of which -
I noticed, after the fact, that the plug wires are supposed to by over the wire loom, not behind it
I think I'm going to finish off the water pump at the from of the valve train and leave it. None of the wrong stuff will show unless I'm doing a full engine. And at least I've got the corrected valve gear in. After all this work I'm going to give up on the full engine idea for now. If I want the whole thing I better start over and do it MUCH LARGER!
This will do for the 4.6 odd inches it will be printed at and for how little will show. But it was FUN!
